Configuring Gts; Configuration Procedure - H3C S7500E Series Configuration Manual

[Sysname-acl-adv-3000] quit
# Create a class named http, and reference ACL 3000 in the class to match HTTP traffic.
[Sysname] traffic classifier http
[Sysname-classifier-http] if-match acl 3000
[Sysname-classifier-http] quit
# Configure a traffic policing QoS policy, and apply the QoS policy to the incoming packets of
GigabitEthernet 2/0/1.
[Sysname] traffic behavior http
[Sysname-behavior-http] car cir 512
[Sysname-behavior-http] quit
[Sysname] qos policy http
[Sysname-qospolicy-http] classifier http behavior http
[Sysname-qospolicy-http] quit
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] qos apply policy http inbound

Configuring GTS

Configuration Procedure

On the H3C S7500E series switches, traffic shaping is implemented as queue-based GTS, that is,
configuring GTS parameters for packets of a certain queue.
Follow these steps to configure queue-based GTS:
To do...
Enter system view
Enter
Enter
interface
interface
view
view or
Enter port
port group
group
view
view
Configure GTS for a
queue
Display GTS
configuration
information on the
interface/all interfaces
Use the command...
system-view
interface interface-type interface-number
port-group manual port-group-name
qos gts queue queue-number cir
committed-information-rate [ cbs
committed-burst-size ]
display qos gts interface [ interface-type
interface-number ]
5-7
Remarks
—
Use either command
Settings in interface view take
effect on the current interface;
settings in port group view take
effect on all ports in the port group.
Required
On SC, SA, and EA LPUs, the
granularity of GTS is 64 kbps.
On SD and EB LPUs, the
granularity of GTS is 8 kbps.
Optional
Available in any view