H3C S7500E Series Configuration Manual page 21

You can only modify the existing rules of an ACL that uses the match order of config. When
modifying a rule of such an ACL, you may choose to change just some of the settings, in which
case the other settings remain the same.
You cannot create a rule with, or modify a rule to have, the same permit/deny statement as an
existing rule in the ACL.
When the ACL match order is auto, a newly created rule will be inserted among the existing rules
in the depth-first match order. Note that the IDs of the rules still remain the same.
You can modify the match order of an ACL with the acl number acl-number [ name acl-name ]
match-order { auto | config } command but only when it does not contain any rules.
Configuring an IPv6 Advanced ACL
IPv6 advanced ACLs match packets based on the source IPv6 address, destination IPv6 address,
protocol carried over IPv6, and other protocol header fields such as the TCP/UDP source port number,
TCP/UDP destination port number, ICMP message type, and ICMP message code.
Compared with IPv6 basic ACLs, they allow of more flexible and accurate filtering.
Follow these steps to configure an IPv6 advanced ACL:
To do...
Enter system view
Create an IPv6 advanced ACL
and enter its view
Configure a description for the
IPv6 advanced ACL
Set the rule numbering step
Use the command...
system-view
acl ipv6 number acl6-number [ name
acl6-name ] [ match-order { auto |
config } ]
description text
step step-value
1-11
Remarks
––
Required
By default, no ACL exists.
IPv6 advanced ACLs are
numbered in the range 3000 to
3999.
You can use the acl ipv6 name
acl6-name command to enter
the view of an existing named
IPv6 ACL.
Optional
By default, an IPv6 advanced
ACL has no ACL description.
Optional
5 by default.