Setup - Stanford Research Systems SR810 Manual

Remote Programming
SETUP COMMANDS
OUTX (?) {i}
OVRM i
KCLK (?) {i}
ALRM (?) {i}
SSET i
RSET i
The OUTX command sets the output interface to RS-232 (i=0) or GPIB
(i=1). The OUTX i command should be sent before any query
commands to direct the responses to the interface in use.
In general, every GPIB interface command will put the SR810 into the
REMOTE state with the front panel deactivated. To defeat this feature,
use the OVRM 1 command to override the GPIB remote. In this mode,
the front panel is not locked out when the unit is in the REMOTE state.
The OVRM 0 command returns the unit to normal remote operation.
The KCLK command sets or queries the key click On (i=1) or Off (i=0)
state.
The ALRM command sets or queries the alarm On (i=1) or Off (i=0)
state.
The SSET i command saves the lock-in setup in setting buffer i (1≤i≤9).
The setting buffers are retained when the power is turned off.
The RSET i command recalls the lock-in setup from setting buffer i
(1≤i≤9). Interface parameters are not changed when a setting buffer is
recalled with the RSET command. If setting i has not been saved prior to
the RSET i command, then an error will result.
5-10