Setup - Stanford Research Systems SR810 Manual

Front Panel

Setup

[Save]
[Recall]
[Aux Out]
Nine amplifier setups may be stored in non-volatile memory.To save a
setup, press [Save] to display the buffer number (1..9) in the Reference
display. Use the knob to select the desired buffer number. Press [Save]
again to store the setup in the buffer, or any other key to abort the save
process.
The message 'SAvE n donE' is displayed if the setup is successfully
saved. The message 'SAve not donE' is displayed if the save process is
aborted.
Nine amplifier setups may be stored in non-volatile memory.To recall a
setup, press [Recall] to display the buffer number (1..9) in the Reference
display. Use the knob to select the desired buffer number. Press [Recall]
again to recall the setup in the buffer, or any other key to abort the
recall process. When a setup is recalled, any data presently in the data
buffer is lost.
The message 'rcal n donE' is displayed if the setup is successfully
recalled. The message 'rcal not donE' is displayed if the recall process is
aborted. The message 'rcal dAtA Err' is displayed if the recalled setup is
not valid. This is usually because a setup has never been saved into the
selected buffer.
The 4 Aux Outputs may be programmed from the front panel. Press
[Aux Out] until the desired output (1-4) is displayed in the Reference
display. The AxOut indicators below the display indicate which output (1-
4) is displayed. The knob may then be used to adjust the output level
from -10.5 V to +10.5 V. Press [Phase], [Freq], [Ampl] or [Harm#] to
return the display to normal.
4-20