Stanford Research Systems SR810 Manual page 122

Performance Tests
d) Use the knob to adjust the Aux Output level to the value from the table.
e) Record the DVM reading.
4) Press
[Aux Out]
Display Aux Out 1 on the Reference display.
5) For Aux Inputs 1 and 2, repeat steps 5a through 5e.
a) Connect Aux Out 1 to Aux Input 1 (or 2) with a BNC cable.
b) Press
[Channel 1 Display]
Set the Channel 1 display to AUX IN 1 (or 2)
c) For each output voltage in table 3c above, repeat steps 5d and 5e.
d) Use the knob to adjust the Aux Out 1 level to the values from the table above.
e) Record the Aux Input 1 (or 2) value from the Channel 1 display.
6) This completes the DC outputs and inputs test. Enter the results of this test in the test record at the
end of this section.
6-14