Functions, Cu 351 (4.5); Display Language (4.5.1) - Grundfos CONTROL MPC Installation And Operating Instructions Manual

11.7.52 Functions, CU 351 (4.5)

Fig. 98 Functions, CU 351
Description
In this submenu, it is possible to make the basic settings of the
CU 351.
CU 351 comes with most of these settings, or they are made at
start-up and normally not to be changed.
The service language, English, can be activated for service
purposes. If no buttons are touched for 15 minutes, the display
will return to the language selected at start-up or to the language
set in section 11.7.53 Display language (4.5.1).
If the service language is selected, the symbol
will be shown to the right of the top line of all
Note
displays.
Setting range
• Activation of service language, British English.
• Re-activation of start-up wizard.
(After start-up, the wizard is inactive.)
• Selection of display language.
• Selection of display units.
• Setting date and time.
• Selection of password for the menus Operation and Settings.
• Setting of Ethernet communication.
• Setting of GENIbus number.
• Reading of software status.

11.7.53 Display language (4.5.1)

Fig. 99 Display language
Description
Here the language for the CU 351 display is selected.
Setting range
• British English
• German
• Danish
• Spanish
• Finnish
• French
• Greek
• Italian
• Dutch
• Polish
• Portuguese
• Russian
• Swedish
• Chinese
• Korean
• Japanese
• Czech
• Turkish
Setting via control panel
1. Mark the Settings menu with
2. Mark Functions, CU 351 with
3. Mark Display language with
4. Select language with
Factory setting
The display language is British English. It can be changed at
start-up.
.
or , and press
or , and press
or , and save with .
.
.
55