Table of Contents
Advertisement
4.2.44
50, 100, and 155 Ipm
Lower Paper Clamp (Continued)
4.2.44.3 Clamp Assembly Removal (Single
Coil Clamp With One Engaging
Lever
m )
Ftemoval
1.
Power down.
2.
3.
4.
5.
Remove the printer covers (4.2.1) and
forms.
Remove the print unit (4.2.10.2).
Unhook cjip
m .
Disconnect P3.
Remove four screws
II
(two each end),
then remove assembly.
Replacement
1.
Place clamp assembly in position. Place
P3 cable as shown and connect plug.
2.
3.
Start the four screws
II ,
but do not tighten.
Hold the assembly against the stop plates
&I '
and tighten the four screws
II .
Install the clip
m .
Do lower paper clamp service check (4.2.44.2).
Do forms tension service check (4.2.45)
steps 4, 5, and 6.
Install print unit and covers.
4.2.44.4 Clamp Bar Removal (Single Coil
Clamp With One Engaging Lever
m)
Removal
1.
Remove lower paper clamp assembly
(4.2.44.3).
2.
3.
4.
Loosen screw, and remove retainer wire
m
from both rods
III .
Unhook spring and remove support pins
Ii
from clamp bar at both ends.
Remove clamp bar from rods
III .
Replacement
1.
2.
3.
4.
Slide the clamp bar into the slot in
rods
Il.
Note:
Ensure that the clamp bar is installed
correctly (tension springs mesh with clamp
bar slots).
Insert the support pin
Ii
and hook the
spring on the pin.
Install retainer wire
a.
Center as shown,
then tighten screw.
Install lower paper clamp assembly
(4.2.44.3).
4-62
4.2.44.5 Coil Assembly Removal (Single Coil
Clamp With One Engaging Lever
m)
Removal
1.
Remove lower paper clamp assembly
(4.2.44.3) .
2.
3.
4.
5.
Loosen screw, and remove retainer wire
a
from both rods
m .
Move armature
D
away from coil.
Loosen screw and remove coil retainer
m.
Remove coil
13
by pulling it off the core.
Replacement
1.
2.
3.
4.
Place coil on core as shown
D.
Install coil retainer
m
and tighten screw.
Hold armature
IJ
toward core, and install
retainer wire
I'J.
Center as shown, then
tighten screw.
Replace paper clamp assembly (4.2.44.3).
Advertisement
Table of Contents
