Table of Contents
Advertisement
9.2.45 Ribbon Feed Rolls
Adjustment
1.
2.
3.
4.
Turn power off at the operator control
panel.
Remove the forms tractor unit (9.2.7).
Remove the printer cover (9.2.1).
Adjust the feed rolls as follows:
a. Loosen the screw that holds the right
hand feed roll
m .
b. Open the feed rolls by pushing the flat
spring to the right
II .
c. Position the right hand feed roll so that
the right feed roll aligns with the left
roll
m.
d. Tighten the screw.
_gI~
--------------------D
--H----m
•
Removal
1.
2.
3.
4.
5.
6.
7.
Turn power off at the operator control
panel.
Remove the forms tractor unit (9.2.7).
Remove the printer covers (9.2.1).
Remove the ribbon (9.2.47).
Remove the right feed roll as follows:
a. Remove the screw
m .
b. Hold the flat spring
0
to the right and
rotate the feed roll
B
toward the platen
area to free it from the spring.
Remove the left feed roll as follows:
a. For installation, install the platen and
adjust the print head.
b. Remove the print head (9.2.34).
c. Remove the screw
EJ
from the left side
of the ribbon box.
d. If the right feed roll is in place, hold the
flat spring
II
to the right and rotate the
left feed roll toward the platen.
To reinstall the feed rolls, reverse this pro-
cedure. Be sure to align the right feed roll
vertically to the left roll
rJ .
Serial Printer
9-47
Advertisement
Table of Contents
