Table of Contents
Advertisement
9.2.40 Ribbon Drive
Removal
1.
2.
3.
4.
Turn power off at the operator control panel
and remove the printer covers.
Remove the print head (9.2.34). Adjust the
print head for installation.
Separate the printer from the power supply
(9.2.2) and place the printer in the service
position.
Remove the drive lines
m
(9.2.44).
5.
Remove the retaining screw from the inside
of the ribbon box
m.
6.
Remove the retaining screw from the left
side of the ribbon box beside the feed
rolls
D.
7.
Lift out the ribbon drive.
8.
To
reinstall the assembly, reverse this
procedure.
9.2.42 Ribbon Drive Clutches
Removal
1.
2.
3.
4.
Turn power off at the operator control panel
and remove the printer covers.
Separate the printer from the power supply
and place the printer in the service position
(9.2.2).
Remove the ribbon lines
II
(9.2.44).
Remove the C-clip from the bottom of the
ribbon clutch shaft
II
5.
6.
7.
For installation, you should be able to turn
both clutches clockwise (when viewed from
the clutch end of the shaft)
II
when the
shaft is held.
Remove the clutches and washers
m
To
reinstall the clutches, reverse this pro-
cedure. Apply a light film of IBM No. 23
grease to the clutch end of the shaft before
installing the clutches.
~
I
I
Serial Printer
9-45
Advertisement
Table of Contents
