Table of Contents
Advertisement
4.2.0 MAINTENANCE
(50, 100, and 155 Ipm)
4.2.1 Printer Cover and Divider
Removal and Replacement
Removal
1.
Remove the left and right knobs
m
by
pulling them from the shaft.
2.
Open the printer cover.
3.
Pull forward on the left and right sliding
latches
m
and remove the printer cover.
4.
Remove the three screws
UI
under the
keyboard, slide the cover forward slightly
to disengage tabs, and remove the keyboard
cover.
5.
Remove the two divider screws
m
and
remove the divider.
6.
The back cover
II
is held on by two ears
on the cover; therefore, it can be lifted off.
Replacement
1.
Replace in the reverse order of removal.
2.
Do the
Cover Interlock Switch
service check
(4.2.2.1).
4.2.1.1 Printer Cover Grounding
II
m
m
II
13
. .
Cable
Cable
Jumper
Jumper (connect to frame of printer behind
right tractor)
Jumper
Jumper
Ground forms stand at grounding blocks.
II
Belt Printer
50, 100, and 155 Ipm
4-17
Advertisement
Table of Contents
