Table of Contents
Advertisement
9.2.6 Platen Pressure Rolls
Adjustment
1.
Remove the printer cover, the platen, and the
paper deflector.
2.
Reinstall the platen.
3.
Open the pressure rolls with the paper release
a
(push the lever to the rear).
4.
Check for a minimum of 0.040 inch (1.02
mm) between the platen and the pressure
rolls at points
m,
Ii,
m
and
II .
5.
If there is insufficient clearance at any of the
points (
III ' B,
m '
or
m ),
adjust the
pressure roll arm
Ii
nearest to the out-of-
tolerance point.
6.
Check the adjustment of the end-of-forms
switch (9.2.17).
7.
Remove the platen.
8.
Reinstall the paper deflector, platen, and
printer cover (9.2.1).
9-18
Advertisement
Table of Contents
