Table of Contents
Advertisement
9.2.30 Carrier Support Shaft
Removal
1.
Turn power off at the operator control panel.
2.
Separate the printer from the power supply
(9.2.2).
3.
Remove the print emitter (9.2.19).
4.
Remove the print carrier drive belt from the
motor.
5.
Loosen the screws on the ends of the carrier
main shaft
II.
6.
Remove the screws from the ends of the
carrier support shaft
Ct.
7.
Spread the side frames enough to free the
support shaft.
8.
To reinstall the shaft, reverse this procedure.
9.
Perform adjustments for the print emitter
pickup (9.2.18), the left margin (9.2.21) and
the carrier main shaft (9.2.28).
D------------------~~~~~~~
Serial Printer
9-37
Advertisement
Table of Contents
