HP 1652B Getting Started page 72

Setting
RS-232C for
Your Non-HP
Printer
The following attributes of the RS-232C interface must be set to the
correct configuration for your printer:
0 Protocol
l
number of stop bits
a parity type
l
Baud rate
a paper width
You can set all of these attributes for your printer by following this
procedure:
1. Press the I/O key to display the I/O menu.
2. Place the cursor on
I/O Port Configuration
and press
SELECT.
3. Place the cursor on the attribute and press
SELECT.
4. When the pop-up is open, place the cursor on the option your
printer requires and press
SELECT.
The pop-up closes, placing
your selection in the box. Repeat this step for all attributes that
you need to change.
5. Place the cursor on
Done
and press
SELECT.
The logic analyzer
will display the menu that was displayed when you selected the
I/O menu.
HP 16528/1653B
Making Hardcopy Prints
Getting Started Guide
B-3