HP 1652B Getting Started page 37

c. With the Alpha Entry pop-up, change the name of the label to
ADDR.
d. Name the second label DATA by repeating steps
a
through c.
-.
3. Assign Pod 1 bits 0 through 15 to the label DATA.
a.
b .
c.
d .
e.
Place the cursor on the bit assignment field below Pod 1 and to
the right of DATA and press SELECT.
Any combination of bits may already be assigned to this pod;
however, you will want all 16 bits assigned to the DATA label.
The easiest way to assign is to press the CLEAR ENTRY key
to un-assign any assigned bits before you start.
Place the cursor on the period under the 15 in the bit
assignment pop-up and press SELECT. This will place an
asterisk in the pop-up for bit 15, indicating Pod 1 bit 15 is now
assigned to the DATA label. Repeat this procedure until all 16
bits have an asterisk under each bit number. Place the cursor
on Done and press SELECT to close the pop-up.
Repeat step c for Pod 2 and the ADDR label to assign all 16
I . brts.
Repeat step c except you will assign the lower eight bits (0 - 7)
of Pod 3 to the ADDR label.
-
Using the State Analyzer
4-8
HP 16528/1653B
Getting Started Guide