Checking For The Correct Fuse; Connecting The Power Cable - HP 1652B Getting Started

-
Checking for
-
the Correct
- Fuse
If you need to check for the correct fuses, remove the fuse module and
look at the amperage and voltage of each fuse. The following figure will
help you locate the 115 V and 230 V fuses. To remove the fuse module,
carefully pry at the top center of the module until you can grasp it and
pull it out by hand. (Refer to, "Selecting the Line Voltage" on the
previous page.)
3.0 A FUSE
3.0 A FUSE
01650E03
Connecting the
The HP 1652B/HP 1653B comes with a 3-wire power cable. When you
Power Cable
connect the cable to an appropriate AC power receptacle, a ground is
provided for the instrument cabinet. The type of power cable you
receive with the instrument depends on your country. Refer to
appendix D of the HP 1652BIHP 1653B Front-Panel Operation
Reference manual for power cord types.
Warning
To avoid possible shock hazard, you must connect the
instrument to a properly grounded 3-wire receptacle.
-
HP 16528/1653B
Getting Started Guide
Introducing the
HP 1652B/HP 16538
I-5