HP 1652B Getting Started page 25

Autoscale
The System Configuration menu has two Autoscale fields. One is for
the timing analyzer, and one is for the scope. If you select either
Autoscale
from the System Configuration menu,the logic analyzer will
display a pop-up with the choices of
Cancel
and
Continue.
The
Cancel
allows you to change your mind before the autoscale is executed.
-. .
Note
4
I @I
When Autoscale is executed, instrument settings for any previous
measurement will change. The new measurement will automatically be
scaled for the best display of the waveform.
If you select
Continue,
the logic analyzer will display the Waveform
menu of either the timing analyzer or the scope. The Waveforms
display that is returned, depends on which Autoscale field you selected.
If there is no signal activity at the probe inputs, the Waveforms menu
will not display data and the label to the left of the waveform area will
be -off-. The figure below shows the waveforms menu for the timing
analyzer after Autoscale was selected.
pmiiEEJ -
Timing Moveforms
tlarkers 1 Off 1 --
Rccumulate
pq
Time/Div 11
Delay 71 Sample period = 20
ns
---
-
-
After an Autoscale, you can get back to the System Configuration
menu by following the steps below.
_-
1. Place the cursor on the Name: field in the upper left corner and
press SELECT.
--
2. Place the cursor on the System field in the pop-up and press
SELECT. You will now be back in the System Configuration menu.
Getting to Know
the
Main Menus HP 16528/1653B
3-4
Getting Started Guide