HP 1652B Getting Started page 63

Set the
probe
attenuation field and the input
Impedance
field as shown
below in the scope Channel menu.
Probe attenuation field
-
Input impedance field
---
--
1. Select the
Probe
field. Using the knob or keypad, set the
attenuation to
1:l.
2.
Select the
Impedance
field. Toggle to 50
Ohms.
---
Making the
Measurement
By selecting the
Autoscale
field, the measurement will automatically be
scaled, positioned, and is displayed on the scope's Waveforms menu as
shown below.
Autoscale field
1 Normal 1 Connect dotslOff1
1.
Select the
Autoscale
field, then select
Continue
from the pop-up.
HP 16528/1653B
Using the Oscilloscope
Getting Started Guide
6-3