HP 1652B Getting Started page 20

-
-
-
-
-
--
-
-
-
Disk Drive
The disk drive is used by the HP 1652B/HP 1653B to load the
operating system every time the logic analyzer is turned on. You will
use the disk drive to load configurations or store configurations,
acquired data, and inverse assemblers for later use. The disk drive uses
3.5inch flexible disks. More information on loading files is found in
Appendix B of this guide. Complete details on the disk drive and its
functions can be found in the HP 1652B/HP 1653B Front-Panel
Operation Reference manual.
ROII
Keys
When part of the listing or waveforms data is off screen, the ROLL
keys define which way the knob will move the displayed data. You will
use these keys and the knob to roll displayed data up/down or left/right
to view data that is off-screen.
-
-
-
HP 1652B/1653B
Getting Started Guide
Knob
The Knob has four major functions depending on what menu or
pop-up menu you are in. The KNOB allows you to do the following
actions:
l
Move the cursor from field to field within the System
Configuration and main menus.
l
Roll the display left or right and up or down.
l
Position the cursor on options within pop-up menus.*,
l
Increment/decrement numeric values in numeric entry pop-ups.
h'lplJtS
The HP 1652B and HP 1653B has both front-panel inputs and rear
panel inputs/outputs. The front panel INPUTS 1 and 2 are for signal
input to the oscilloscope. BNC cables or oscilloscope probes can be
used.
Logic analyzer probe inputs, labeled by POD and CLOCK, are located
on the rear-panel. In addition, a Probe Compensation Signal, and
EXTERNAL TRIGGER IN/OUT BNCs are on the rear-panel.
Getting to Know the Front Panel
2-3