SonicWALL TZ 210 Series Getting Started Manual page 82

TZ_210_GSG.book Page 71 Thursday, November 13, 2008 7:41 PM
Safety and Regulatory Information for the
SonicWALL TZ 210 Wireless Appliance
Regulatory Model/Type
APL20-065
APL20-064
Mounting the SonicWALL
Mount in a location away from direct sunlight and sources
•
of heat. A maximum ambient temperature of 104º F (40º C)
is recommended.
Route cables away from power lines, fluorescent lighting
•
fixtures, and sources of noise such as radios, transmitters,
and broadband amplifiers
The included power cord is intended for use in North
•
America only. For European Union (EU) customers, a power
cord is not included.
• Ensure that no water or excessive moisture can enter the
unit.
Allow unrestricted airflow around the unit and through the
•
vents on the side of the unit. A minimum of 1 inch
(25.44mm) clearance is recommended.
Consideration must be given to the connection of the
•
equipment to the supply circuit and the effect of over-
loading the circuits has minimal impact on overcurrent
protection and supply wiring. Appropriate consideration
of equipment nameplate ratings must be used when
addressing this concern.
Product Name
TZ 210 Wireless, TZ 210 W
TZ 210 Wireless, TZ 210 W
Lithium Battery Warning
The Lithium Battery used in the SonicWALL security appliance
may not be replaced by the user. Return the SonicWALL security
appliance to a SonicWALL-authorized service center for
replacement with the same or equivalent type recommended by
the manufacturer. If, for any reason, the battery or SonicWALL
security appliance must be disposed of, do so following the
battery manufacturer's instructions.
Cable Connections
All Ethernet and RS232 (Console) cables are designed for intra-
building connection to other equipment. Do not connect these
ports directly to communication wiring or other wiring that exits
the building where the SonicWALL is located.
Power Supply Information
If the power supply is missing from your SonicWALL product
package, please contact SonicWALL Technical Support at 408-
752-7819 for a replacement. This product should only be used
with a UL listed power supply marked "Class 2" or "LPS", with an
output rated 12 VDC, minimum 1.66 A.
SonicWALL TZ 210 Series Getting Started Guide Page 71