SonicWALL TZ 210 Series Getting Started Manual page 53

TZ_210_GSG.book Page 42 Thursday, November 13, 2008 7:41 PM
Completing the Public Server Wizard
The Public Server Wizard guides you through a few simple
steps, automatically creating address objects and rules to allow
server access. To complete the public server wizard, perform
the following steps:
1. Click the Wizards button in the upper right corner of the
SonicOS management interface to launch the wizard.
2. Select Public Server Wizard and click Next to continue.
3. Select Web Server as the server type and ensure that the
HTTP and HTTPS services are selected.
Tip:
HTTPS is required for servers authenticating SSL or
other HTTPS-supported encryption methods. If your
server does not require encryption, you can de-select
the HTTPS service.
4. Enter a Server Name in the field that is easy to remember
such as "My Web Server". This name is for your reference
and does not necessarily need to be a domain or address.
5. Enter the Private IP Address of your server. This is the IP
address where the server will reside within the DMZ zone.
If you do not have a DMZ configured yet, select a private IP
address (such as 192.168.168.123) and write it down, you
will need to refer to this later.
Page 42 Public Server on DMZ
6. Enter a Server Comment (optional) and click Next.
7. Enter the Server Public IP Address in the field (normally
your primary WAN IP address). This IP Address is used to
access your Web server from the Internet.
8. Click Next and then click Apply to finish the wizard.
Note:
If your server is on the LAN zone, you have completed
the required steps for basic server access.
If you wish to continue with an advanced DMZ zone
configuration, turn to the Configuring a DMZ Zone
section, on page 43.