SonicWALL TZ 210 Series Getting Started Manual page 50

TZ_210_GSG.book Page 39 Thursday, November 13, 2008 7:41 PM
Assigning an Interface to the Wireless Zone
Once the wireless zone is configured, you can assign an
interface to it. This is the interface where you will connect the
SonicPoint.
1. On the Network > Interfaces page, click the Configure
icon on the row of the interface that you want to use, for
example, X3. The interface must be unassigned.
2. In the Edit Interface dialog box on the General tab, select
WLAN or the zone that you created from the Zone drop-
down list. Additional fields are displayed.
3. Enter the IP address and subnet mask of the Zone in the IP
Address and Subnet Mask fields.
4. In the SonicPoint Limit field, select the maximum number
of SonicPoints allowed on this interface. If you want to
enable remote management of the SonicWALL security
appliance from this interface, select the supported
management protocol(s): HTTP, HTTPS, SSH, Ping,
SNMP, and/or SSH.
5. If you want to allow selected users with limited
management rights to log in to the security appliance,
select HTTP and/or HTTPS in User Login.
6. Click OK.
SonicWALL TZ 210 Series Getting Started Guide Page 39