SonicWALL TZ 210 Series Getting Started Manual page 36

TZ_210_GSG.book Page 25 Thursday, November 13, 2008 7:41 PM
PortShield Wizard
With PortShield, multiple ports can share the network settings of
a single interface. The SonicWALL PortShield feature enables
you to easily configure the ports on the SonicWALL TZ 210
series appliance into common deployments.
Tip:
Zones can always be applied to multiple interfaces in
the Network > Interfaces page, even without the use
of PortShield groupings. However, these interfaces will
not share the same network subnet unless they are
grouped using PortShield.
To configure ports using the SonicWALL PortShield Wizard:
1. Click the Wizards button on the top-right of the SonicOS
management interface.
2. Choose PortShield Interface Wizard and click Next.
3. Select from the following:
Selection Port Assignment Usage
WAN/LAN X0, X2-X6: LAN Connect any local network device to X0, or
X1: WAN X2-X6 for local and Internet connectivity.
WAN/LAN/ X0, X3-X6: LAN Connect any local network device to X0, or
DMZ X1: WAN X3-X6 for local and Internet connectivity.
X2: DMZ
Connect public-facing servers or other
semi-public resources to X2.
4. WAN/LAN or WAN/LAN/DMZ and click Next to
continue.This will prompt a configuration summary to
appear. Verify that the ports assigned are correct.
5. Click Apply to change port assignments.
Note:
For more information about PortShield interfaces, see
the SonicOS Enhanced Administrator's Guide.
SonicWALL TZ 210 Series Getting Started Guide Page 25