Verifying Security Services On Zones - SonicWALL TZ 210 Series Getting Started Manual

TZ_210_GSG.book Page 19 Thursday, November 13, 2008 7:41 PM

Verifying Security Services on Zones

Security services such as Gateway Anti-Virus are automatically
applied to the LAN and WAN network zones. To protect other
zones such as the DMZ or Wireless LAN (WLAN), you must
apply the security services to the network zones. For example,
you can configure SonicWALL Intrusion Prevention Service for
incoming and outgoing traffic on the WLAN zone to add more
security for internal network traffic.
To apply services to network zones:
1. Navigate to the Network > Zones page.
2. In the Zone Settings table, click the Configure icon for the
zone where you want to apply security services.
3. In the Edit Zone dialog box on the General tab, select the
checkboxes for the security services to enable on this
zone.
4. Click OK.
Congratulations! Your SonicWALL TZ 210 series appliance is
registered and fully functional with active UTM security services
enabled.
For advanced network setup information, continue to:
Advanced Network Configuration
•
Advanced Deployments
• - page 33
SonicWALL TZ 210 Series Getting Started Guide
- page 21
Page 19