Stretch Stitch Feed Balance - ELNA 6125QC Service Manual

Mechanical Adjustment

Stretch Stitch Feed Balance

If the stretch stitch patterns are deformed when sewing the patterns with the feed balancing dial is set at the
standard position " ", correct it as follows:
Adjustment procedure:
1. Select the straight stretch stitch " " and set the stitch width control at "0".
2. Set the feed balancing dial at the standard position " ".
3. Place a piece of paper on the machine and lower the presser foot. Rotate the handwheel several turns
and check the needle marks in the paper.
4. Remove the cap on the rear cover to access the adjusting screw.
5. If the forward feed is longer (A>B): Turn the adjusting screw in the direction of (C).
6. If the backward feed is longer (B>A): Turn the adjusting screw in the direction of (D).
7. Attach the cap.
(C)
Adjusting screw
(D)
Feed blancing dial
Cap
16