Replacement Of B-Board And Fuse (Applicable To Model 6125Qc Only) - ELNA 6125QC Service Manual

Replacement of B-Board and Fuse
(applicable to Model 6125QC only)
1. Remove the rear cover (See page 9.).
2. Remove the setscrews (A) and (B). Remove the circuit box lid.
3. Remove the 4 setscrews (C) and pull out all the connectors.
4. Replace the B-board and attach it with the setscrews (C).
5. Insert the connectors (See page 28 for connector location.).
6. Attach the circuit box lid and rear cover.
To replace the fuse:
1. Pry out the fuse with a screwdriver.
2. Replace the fuse and push it down into the fuse clip.
Circuit box lid
Setscrew (A)
Setscrew (B)
Setscrews (C)
Fuse (250V 2A)
Setscrews (C)
30