Table of Contents
Advertisement
(Note)
"With Fast-dump" setting gets invalid except in Preset/Asynchronous shutter operation.
(Note)
Carefully note that the operation is not guaranteed if an unusable function is selected.
[Shutter mode]
Functional limitation by shutter mode
●
Current shutter mode
No shutter
Continuous shutter
Asynchronous shutter
*1......Usable only in preset/asynchronous shutter operation.
(7-9) Read out of factory default
This procedure is for reading out the factory default (initial setting before shipment) in order to initialize the setting that was
changed by the user after purchase.
The factory default is shown by the table below.
[Factory default of each register]
Program page item
(Stored in each program page)
Applied to page A to F
※
Configuration item
(Stored in common area)
(Note) (Factory default) is the adjusted value for each camera.
(!) The factory setting of configuration register for this camera is CR=H'0008 and the image output format is 8bit.
[The procedure for restoring the setting to factory default]
①
Transmit " e " command by serial communication.
②
Turn off the power to the camera. Several seconds after that , restore the power.
→ The settings inside the camera (contents of nonvolatile EEPROM) are restored to the factory default of the upper table by this
operation.
(Note) Note that the contents having being set by the user are all lost by executing upper procedures.
Product introduction
Communication software for evaluation
Takenaka's free software "FCTool" is available to set parameters inside the camera
via serial communication at the time of product evaluation or initial setting.
It is free to download FCTool from the website of TAKENAKA SYSTEM Co.,Ltd.
http://www.takex-system.co.jp/
AGC
AEC
operation
operation
O
O
O
O
X
X
Storage area (Register)
Flag register (FR)
MGC gain set value
AGC gain set value
Offset set value
Direct designated value of shutter speed
Electric shutter table
Configuration register (CR)
Hypothetical shutter switch
Hypothetical mode switch
ID data
Vsub voltage set value
- 35 -
Auto iris lens
Draft scan
O
O
O
O
X
X
Factory default
FR = H'0000
(Factory default)
(Factory default)
(Factory default)
H'0000 (none specified)
Contents of table 5-3
CR=H'0008
0
A
Blank
(Factory default)
FCTool
M10510B;35/58
Prolonged exposure Fast-dump
O
O
X
X
X
O *1
Advertisement
Table of Contents
