Table of Contents
Advertisement
③ Save CR data to enable the settings at next start-up.
As the CR data set on
the time of power-off.
It is needed to send the "SMC" command and to save the set values
into the internal nonvolatile ROM(EEPROM) to enable CR data
even after next start-up.
[Example]
Right figure shows the example of transmitting the command "SMC" using the direct
command of FCTool.
(Note) When using FCTool, "SMC" command can be performed following next
procedure as well.
Select Tools
Click the "OK" button on "OK to save confirmation?" screen.
● Switching of the menu page
Set contents are displayed item by item on the plural menu pages.
"WMP" command is used to change the menu page.
[Example]
Right figure shows the example of transmitting the command "WMP3"
using the direct command input of TAKENAKA's communication software for evaluation (FCTool) to switch the menu
page to "MENU3".
● Description of display content
Current settings of MENU 1,2,3,4 are displayed.
<MENU1> Display content
MENU:
Current menu status is displayed.
While the menu is being displayed, "ON" is kept displayed.
When "(CYCLIC)" is displayed on the right side, the camera is
cyclically outputting the asynchronous shutter image using the
internal trigger to refresh the image.
When the asynchronous shutter mode is set and the menu is set
to ON, the cyclic trigger input is automatically selected. When the
menu is set to OFF, the cyclic trigger input is automatically
cancelled and external trigger is ready to be received.
GAIN:
The left number is the gain setting value expressed in the decimal
system. (Range: 0 to 255). The item which is currently valid
among MGC/AGC/AEC is displayed on the right side.
OFFSET:
The set value of the digital signal offset is displayed in the decimal system. (Range: 0 to 255)
S.TIME:
The current shutter exposure time is displayed. The left number is H number (horizontal synchronous time
unit, in the case of high speed shutter) or V number (vertical synchronous time unit, in the case of low speed
shutter). The right number in parentheses shows the actual time.
The actual time is displayed after being converted in accordance with the settings of the shutter mode
(HIGH/LOW).
(Note) When the pulse width control mode is set for the asynchronous shutter operation or when a shutter setting value is
out of the predetermined range, the actual time is displayed as "--.-".
S.FORM:
The current shutter operation mode is displayed. The left is either continuous (NORMAL) or asynchronous
(ASYNC), and the right is either high speed (HIGH) or low speed (LOW).
SCAN:
The current scanning system is displayed. It is either all pixel readout scan (NORMAL) or partial readout
scan (PARTIAL).
are stored only on RAM, it will be lost at
②
Save
Configuration Flags in series on the menu bar.
→
→
- 32 -
M10510B;32/58
* M E N U １
M E N U
:
O N ( C Y C L I C )
G A I N
:
1 6 0
/ M G C
O F F S E T :
1 4 0
S . T I M E :
1 7 0 h
(
8 . 3 5 ) m s
S . F O R M : A S Y N C
/
H I G H
S C A N
: N O R M A L
Tc=
55
M S = A S S = 7
M F = 0 0 0 0 . 0 0 0 1
F S 5 0 0 0 G E
[ V . X . X X ]
Menu 1 display
deg
Advertisement
Table of Contents
