Table of Contents
Advertisement
(Example4) Exposure time setting – Asynchronous shutter – Designation of Preset value
The example of the way to set the shutter exposure time to Preset 5 is shown below.
Set the following set of parameters.
① Set to "TriggerCntrolled" on the item "AcquisitionAndTriggerCntrols > ExposureMode
② Select "Preset5" on the item "AcquisitionAndTriggerCntrols > PresetShutter
(Example5) Exposure time setting – Continuous shutter – Designation of Absolute time (in ms unit)
The example of the way to designate the shutter exposure time in
continuous shutter mode is shown below. (e.g. 40000
Set the following set of parameters.
① Set to "Timed" on the item "AcquisitionAndTriggerCntrols > ExposureMode
② Set to "ExposureTime" on the item "AcquisitionAndTriggerCntrols > PresetShutter
③ Enter "40000" on the item "AcquisitionAndTriggerCntrols > ExposureTimeAbs".
And press the return key.
(Note) The example of setting and entering numerical number "40000" with FC5200GE (*)
is shown in the right figure.
"3999.3"
s corresponding to the numerical number "40000"
μ
actually assignable number.
This is because the shutter speed is set in H(horizontal synchronous time) unit on
the camera side.
→ It turns out that the value of "ExposureTimeRaw" gets "814" In response to the
value "40000"
s. That means H number "814" which is closest to the set value
μ
"40000"
s is set into the camera.
μ
*
Further details of each numerical number vary with the type of camera.
The above example shows the case of FC5200GE(5 megapixels/GigE)
(Example6) Image output format setting
The example of the way to switch the image output format from 8 bit (default) to
10 bit is shown below.
Select "mono10" ("Bayer RG10" in the case of color camera) on the item
●
" ImageSizeControl > PixelFormat " and press the return key.
(Example7) Saving the settings
The example of the way to save the set contents of parameters making it
reflected at next power-on is shown below.
① Select "UserSet1" on the item "UserSets > UserSetSelector
② Click the command button on the item "UserSets > UserSetSave
③ Select "UserSet1" on the item "UserSets > UserSetDefaultSelector
And press the return key.
* Set values are saved in the XML file inside the camera herewith and is applied at
next power-on.
(Example8) Default setting restoring (Reloading of Default setting)
The example of the way to restore the settings of various parameters to default
is shown below.
①
Select "UserSet1" on the item "UserSets > UserSetDefaultSelector
②
button to disconnect the connection.
Click "Disconnect"
*In this way, the camera gets started by default setting at next power-on.
→ After restarting, return the item "UserSetDefaultSelector
(Note) It is always set to default at startup if "UserSetDefaultSelector " is set to "Default".
※ Other setting parameters
Refer to chapter 9 for more details about other setting parameters(Features).
" and press the return key.
s unit in
μ
s=40ms)
μ
".
s is reflected as an
μ
".
".
"
.
".
"
" after having saved set values in
to "UserSet1
- 22 -
M10510B;22/58
".
".
"UserSet1
".
Advertisement
Table of Contents
