Introduction; Set Up; Unpacking And Setting Up Your Muw - Adam Equipment UG119 User Manual

EN
1.0

INTRODUCTION

The MUW Health and Fitness scale provides the weight and height of a patient
before calculating the BMI based on the results. Each result will be displayed on
the Indicator and held until the result is cleared, the BMI result can be used to
help evaluate some ones overall health. Units of weighing are Kg, Lbs, and Lbs
and Ounces. Height measurements are displayed in cm, feet and inches, and
inches. There is an internal rechargeable battery as well as wheels fitted to the
base that make the MUW totally portable. The results can be sent to a printer
or PC via the RS232 communication port, either manually or automatically.
2.0

SET UP

2.1

UNPACKING AND SETTING UP YOUR MUW

The MUW has been packed in such a way to make it quick and easy for the
USER to assemble, please follow the instructions as below.
1) Remove the base and pillar sections from the packaging.
2) Lift the lower pillar section and place it with the screw holes at the rear
onto the back of the base allowing for the cable to hang freely in the
open area.
3) Fit and tighten the 4 x M5 x 15 bolts and washers through the fixing plate
of the lower pillar section and into the base then slide the pillar cover
down so that it locates securely. Fix the pillar cover at the rear using 2 x
M4 x 10 screws.
4) Lift the central pillar section into position and slide it with the screw
holes at the rear onto the fixing insert ensuring the cable hangs freely
inside the pillar.
5) Fit and tighten 4 x M4 x 10 screws through the pillar and into the insert.
6) Lift the top pillar section into position and slide it onto the fixing insert
with the sensor housing facing the front, again ensuring the cable hangs
freely inside the pillar.
7) Fit and tighten 4 x M4 x 10 screws through the pillar and into the insert.
© Adam Equipment Company 2012 2 700660229revA-Jul12