Moneual RYDIS MR7700 User Manual page 9

Electrical cautions
Make sure to use only the specified voltage and current.
Power supplies outside the specification ranges may cause a serious damage to the product.
The battery can become discharged if the product is not used for a long time.
When storing the device for a long period of time, make sure to turn off Power switch on the rear.
Do not use a damaged power cord or plug.
There is chance of shock and/or serious injury.
If the power cord of the charger is damaged, contact the service center immediately.
Make sure that the power cord is not pulled or pressed down by doors.
The power cord can be pulled out or damaged.
When connecting / disconnecting the plug into / from the receptacle, make sure to do so by
holding the plug part, rather than pulling on the cord.
Do not touch the power cord with wet hands.
You can get shocked.
If the product is wet, pull out the power cord, and dry up the product before use.
An electric shock or a fire may occur. If water enters the product, contact the service center.
Use the enclosed charger only.
The product may be damaged due to overvoltage, or a fire or electric shock may occur.
Do not bend the power cord with excessive force or place heavy objects on it.
A damaged cord may cause an electric shock or a fire.
Do not install the charger in a place which is damp or dusty, where water splashes or where
steam is emitted.
The product may malfunction, or a shock or damage of the product may occur.
Do not contact any metal objects such as clip and pin to the charger terminal.
It can cause electric shock and fire.
For indicator power, use rated batteries and adapters.
If not, the product can be damaged set on fire or it may not work.
In case of insufficient indicator battery, replace with a new one.
Without batteries, indicator functions may not work normally.
RYDIS MR7700 User Manual 9