Using The Indicator; Using The Product In The Room Assortment Mode - Moneual RYDIS MR7700 User Manual

Using the indicator

The indicator enables you to separate spaces into different zones within your home.
Using the room assortment mode or setting a cleaning area enables you to make good use of
the indicators.
Check the indicator battery status.
Press any button to check if the lamp blinks; if so, it means the indicator is turned on.
If the battery becomes depleted, press the button; all the lamps will blink at the same time.
In this case, you need to replace the battery.
If you do not want to use the indicator, turn off the power switch in the rear to conserve battery.
Using the product for the room assortment mode
01. Place the indicator against a wall on the floor at the entrance of a room.
If the indicator is put at a place 10cm or higher than the floor, the robot cleaner may fail to identify it.
In general, you can install the indicator at the position marked with the symbol (
below.
Up to three (3) indicators can be installed.
If there is a door where the indicator is installed, leave the door open so the robot has access to the room.
The indicator is not included with the standard package but can be purchased separately
if needed.
Room #1
Living Room
02. Press the [Mode] button to set the product into [Indicator] mode.
When the lamp turns on, repeatedly press the button until the [Indicator] lamp gets turned on.
03. Press the [Distance] button to set a door width.
Repeat pressing until the setup is made for the door width.
1m(●) - 3m(●●) - 5m(●●●)
For the average home, 1m setup is adequate.
If the distance is set too excessively, the robot cleaner may not function correctly.
38 RYDIS MR7700 User Manual
Room #2
Room #3
Front side
) seen in the figure