Using Through Setup Of Cleaning Areas - Moneual RYDIS MR7700 User Manual

Using thorough setup of cleaning areas
■ You can make the robot cleaner work only within a specified space (gray area in the figure).
■ In addition to the example below, you can make other spaces in various forms.
■ Indicator signals are transmitted into three front/right/left directions.
Indicator (The pointy part is the front.)
Transmission signal (up to 5m)
Robot cleaner
01. Press the [Mode] button to set the [Set cleaning areas] mode.
When the lamp gets turned on, repeatedly press the button until the [Set cleaning areas] lamp is
turned on.
02. Press the [Distance] button and adjust the distance of signals to set cleaning areas.
Repeat the pressing of the button until the distance of signals to set cleaning areas is set at the desired
level. 1m(●) - 3m(●●) - 5m(●●●)
If the distance is set as too short or too long, the robot cleaner may not properly understand the area.
03. Calculate the signal distance to arrange the indicator in the appropriate position.
If the signal does not reach the wall, the robot cleaner may slip through the crack.
40 RYDIS MR7700 User Manual