Replacing the filter
To reuse the filter, you must water-clean it after removing it from the dust box.
Do not use any detergent; use only water.
For removal of the filter, see Step 3 in the "Cleaning the dust box"section.
Replace the filter every three to six months. An overused filter cannot deliver full performance.
The life span of the filter can decrease depending on its usage environment.
Cleaning the falling point-detecting sensor
01. Turn the robot cleaner over.
02. Use the cleaning brush or a cotton swab to clean the three sensors as shown in the
picture below.
Do not directly moisten or use benzene or alcohol to clean the sensors.
44 RYDIS MR7700 User Manual
Brush
Cotton Swab