Maintenance - baltur BTG 15ME Instruction

MAINTENANCE

The burner does not require special maintenance, but it is good practice to check periodically that the gas filter is
clean and that the ignition electrode is efficient. It is also necessary to verify that the ignition electrode's spark is
produced between the same electrode and the disk. The combustion head may need cleaning. Take care during
re-assembly to exactly centre the electrodes (one for switching on and one for flame detection) to prevent these
going to ground and blocking the burner. Most of the components can be inspected by removing the housing; to
inspect the head you must remove the mixing unit, proceeding as explained below.
1) Undo the lid screw "A" to gain access to the
interior of the burner.
2) After disconnecting the gas train, unscrew the
3 screws "B" that fasten the flange of the gas
outlet connector to the burner plate.
3) Remove the mixer unit in the picture.
37 / 68
000608220_2007/03