Configuring The Instrument - AEMC 6417 User Manual

Clamp-on ground resistance tester

Hide thumbs Also See for 6417:

Table of Contents

7.4 Configuring the Instrument

To configure the instrument, perform the following steps.

1. In the Control Panel, select Instrument in the menu bar and click the

Configure option.

NOTE: If a connection has not been previously established, the

Communication dialog box will appear (see Figure 7-8).

2. Once identification is complete, the Configuration dialog box will appear

(if not already open).

This dialog box allows you to configure options for each of the following settings:

■ Alarm Z: Enables/disables the alarm, specifies the impedance alarm

■ Alarm V: Enables/disables the alarm and specifies the voltage

■ Alarm I: Enables/disables the alarm and specifies the current threshold

■ Loop Alarm: Enables/disables the alarm and specifies the threshold

■ Z Frequency: Selects the desired test frequency.

■ Buzzer: Enables/disables the feedback buzzer of the instrument.

■ Automatic stop: Enables/disables automatic stop of the instrument.

uality Products Online at:

threshold and whether or not the alarm should be triggered when the

measured value is above or below the specified threshold.

threshold for the alarm.

for the alarm.

for the loop alarm.

GlobalTestSupply

www.

Figure 7-9

Clamp-on Ground Resistance Tester Model 6417

.com

sales@GlobalTestSupp

Table of Contents