Operation; Inserting The Batteries; Setting The Date And Time - AEMC 6417 User Manual

5.1 Inserting the Batteries

NOTE: The alkaline batteries can be replaced by NiCd or NiMh rechargeable
batteries (AA, 1.2V) having similar characteristics. However, the time between
the low battery message and the Auto Power OFF will be shorter with the
rechargeable batteries.
Used batteries must not be treated as ordinary household waste. Recycle
them appropriately.

5.2 Setting the Date and Time

Setting the clock, which is used for time-stamping measurements, is done only
the first time the clamp is used or after it has been without battery power for more
than two minutes.
Set the function switch to Ω+A. All icons on the display light for approximately
two seconds. Enter the date and time using the ▲, ▼, and ► buttons.
The date and time can also be configured before a measurement in SET-UP (see
§ 4.4, menu #7 & #8).
NOTE: If time-stamping is not needed, this operation can be skipped by pressing
the
Ω
(
22
uality Products Online at:

5. OPERATION

+
+ +
Figure 5-1
► button until the measurement screen corresponding to the switch setting
+A, A, MR or SET-UP) is displayed.
GlobalTestSupply
www.
■ Unclamp and remove the instrument
from any connections and turn the rotary
switch to the OFF position.
■ Use a Philips head screwdriver to
unscrew the two attachment screws and
remove the battery compartment cover.
■ Remove the old batteries and replace
them with four new batteries (LR6, AA,
+
1.5V), observing the polarities.
■ Close the battery compartment cover and
tighten the two screws.
■ Check for the proper operation of the
device.
Clamp-on Ground Resistance Tester Model 6417
.com
sales@GlobalTestSupp