Making A Measurement; Rotary Position - (Mr); Displaying Stored Measurements - AEMC 6417 User Manual

6.2.1 Making a Measurement

■ Turn the rotary switch to the A position, and wait several seconds while
■ Clamp around the conductor to be measured. If the clamp is incorrectly
■ If necessary, use the HOLD button to freeze the measurement.
■ If necessary, use the MEM button to store the measurement.
Once the measurement has stabilized, the display will indicate the value of the
current flowing in the conductor.
NOTE: If the preset alarm threshold is
exceeded, the threshold set value and the
value of the current measured blink.

6.3 Rotary Position - (MR)

The MR position (Memory Recall) is used to display measurements previously
stored when the MEM button was pressed.

6.3.1 Displaying Stored Measurements

■ Set the function switch to the MR position.
■ The type of data that is displayed is dependent on whether Standard or
6.3.1.1 Data Displayed in Standard Mode
The last measurement is displayed. The MR
symbol and the sequence number of the
record being recalled are also displayed.
Figure 6-11 illustrates an impedance plus a
current measurement (Ω+A setting).
Clamp-on Ground Resistance Tester Model 6417
uality Products Online at:
the instrument performs internal calibration.
closed, the icon is displayed.
Advanced mode was selected during SET-UP (see § 4.4, menu #9).
GlobalTestSupply
www.
Figure 6-10
Figure 6-11
.com
sales@GlobalTestSupp
33