Table of Contents
Advertisement
SP2/SP8/SP8-X20 Manual
2) You will now get an MS DOS command prompt which shows the ping results. If this is
unsuccessful you will receive a "request timed out" message.
Having connection problems? Please note:
The units default connection speed is 10MB w/Half Duplex, so if you are having trouble
connecting to the unit then you do have the option to set the unit to full duplex mode by using the
follows SNMP set command
snmpset -v1 -c public 192.168.0.100 .1.3.6.1.4.1.3854.1.2.2.1.72.0 s "1yyy"
To set back to halfduplex -->
snmpset -v1 -c public 192.168.0.100 .1.3.6.1.4.1.3854.1.2.2.1.72.0 s "0yyy"
where 'public' is admin password. Where '192.168.0.100' is the sensorProbe's IP address. The
duplex mode is shown on Network Settings page.
Quick Tip:
If you're still having trouble connecting to your sensorProbe, or opening your unit's web interface,
please see the FAQ in section #7 at the end of the manual for more help.
Updated until firmware 413
- 9 -
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the sensorProbe8 and is the answer not in the manual?
Questions and answers