System Settings; Network Settings - AKCP sensorProbe8 User Manual

When you have filled in your required fields remember to click "Save".
d) At the bottom of the page you have two further options.
Status of most recent Mail :- This can be either "No Status" "Success" or "Failure"
Last Error Message :- This is a debugging aid. If the email is not successfully sent, you may find
the reason for the problem here.
Test Email :- Useful when you first set up the SMTP settings to ensure they are working, or
anytime thereafter. Before a test mail can be generated ensure the previous fields described have
been completed.
Quick Tip:
If you having problems connecting to your SMTP email server, then please find some trouble
shooting tips in the FAQ section #7 at the end of this manual.

5) System settings

1) Network settings

The networks settings page allows you to change network settings for your unit such as the IP
address etc.
To get to the entry point of this tutorial complete the following :-
1) Point your web browser to the IP address of your unit
2) Log in as administrator
3) From the settings page, select the network tab.
Quick Tip:
You can change your default HTTP port on the unit using this SNMP set command:
snmpset -m all -v1 -c <community> <ipaddress> .1.3.6.1.4.1.3854.1.2.2.1.91.0 u <port>
You can still use port 80 for web access as well.
Updated until firmware 413 - 21 -
SP2/SP8/SP8-X20 Manual