AKCP sensorProbe8 User Manual page 28

SP2/SP8/SP8-X20 Manual
d) Next you have the options for resetting the SNMP trap settings
SNMP Port :- Use this option to reset the SNMP port setting to its default
SNMP Trap Port :- Use this option to reset the SNMP Trap Port to its default setting
Quick Tip:
Your SNMP port default is 161 and the SNMP TRAP port default is 162. You can set your SNMP
ports with the following commands:
snmpset -m all -v 1 -c <community> <ipaddress> .1.3.6.1.4.1.3854.1.2.2.1.99.0 u <new snmp
port>
snmpset -m all -v 1 c <community> <ipaddress> .1.3.6.1.4.1.3854.1.2.2.1.100.0 u <new snmp
trap port>
e) Finally you have the option for setting up the system log parameters.
Clear Syslog :- Used to clear the system log of the messages for the unit
Remote Syslog :- You can set up the unit to send its syslog message in a standard format
acceptable to a remote syslog server. For example, the Logalot system from Somix.
Remote Syslog IP Address, Remote Syslog Port :- You can set the IP address and port of the
remote syslog server to which the unit will send the log messages.
Quick Tip:
One way to export your sensor data in real time to a remote location is with the "Remote Syslog"
feature. If you want to use the "Remote Syslog" feature for this, please find more detailed
information on how to set this up in the FAQ section #7 at the end of this manual.
Updated until firmware 413 - 28 -