Table of Contents
Advertisement
SP2/SP8/SP8-X20 Manual
a) After going to the "traps" tab you can see the two traps ("Trap 1", "Trap 2")
b) The traps have various fields you need to set. These are explained below.
Send Trap :- toggles whether the SNMP trap is on or off
Destination IP :- The destination IP address that the trap message will be sent too.
Updated until firmware 413
- 17 -
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the sensorProbe8 and is the answer not in the manual?
Questions and answers