Table of Contents
Advertisement
Operating instructions SPIKE adaptive bike
22.2 Service schedules
There is some maintenance work or checks
which should be carried out by the user
themselves at regular intervals (approximately
every 4 weeks depending on the frequency of
use):
The chain should be cleaned and
lubricated with chain oil (observe the
manufacturer's instructions).
Check the tyres for damage, foreign bodies
and any cracks that form.
Check the cable housings are seated
correctly and tightly in the gear cable
holders.
Cables and lines should be checked for
kinks and crushing.
Check the brake pads.
Check the tyre pressure and correct if
needed (the tyre pressure should always
be as printed on the tyre covers).
If you should discover any problems
during these checks, please immediately
contact your dealer or PRO ACTIV. Service
and repair work on the product may only be
carried out by your dealer or PRO ACTIV.
In addition to these maintenance tasks /
checks by the user, PRO ACTIV has
prescribed maintenance tasks to be carried
out by the dealer or PRO ACTIV for safe
operation of the product and to minimise the
risk to the user or third-parties.
The initial inspection is performed after running
200 kilometres or 5 months after delivery
(whichever comes first). The maintenance
schedule can be found in the inspection lists in
chapter 30.
Subsequent inspections are then always
performed after 1,000 kilometres running or
after a period of 1 year (whichever comes first).
The maintenance schedule can be found in the
inspection lists in chapter 30.
After extreme loads, e.g. during holidays where
the product was used on sand, near sea water
or in snow, it is recommended that an
additional deep clean and inspection is
performed by your dealer or PRO ACTIV.
To maintain the operating licence and the
warranty validity, the performance of the
maintenance tasks must be documented. Any
faults identified during maintenance work must
be rectified and documented as such before
further use of the product.
Even if your product does not show any signs
of wear, damage or malfunctions, the regular
safety-related checks on your product must be
carried out in accordance with the
maintenance schedule.
22.3 Proof of maintenance
To provide proof of the maintenance, you can
use the inspection lists in chapter 30. The
inspection lists are also available as pdf files
which can be filled in within the download area
of
www.proactiv-gmbh.com
"more documents >>". In any event, keep all
documents / service reports as a means of
proof, and get any service work which was not
carried out by PRO ACTIV documented.
Please bring these operating instructions /
service booklet to every service.
23 Disposal & Recycling
At the end of the service life, the product can
be disposed of by PRO ACTIV or your dealer
in a proper, environmentally-friendly manner.
The disposal or recycling must be carried out
by a waste disposal company or a municipal
waste disposal centre.
Special guidelines may apply on-location with
regard to the disposal or recycling. These must
be clarified and considered when disposing
(this may also include the cleaning or
disinfection of the product before the disposal).
In the following section, you will find a
description of the materials for the disposal
and recycling of the product and its packaging:
under the link
18
Advertisement
Table of Contents
