ProActiv NJ1 Operating Instructions Manual
Hide thumbs
Also See for NJ1:
- Usage instructions (48 pages) ,
- Operating instructions manual (36 pages) ,
- Operating instructions service booklet (36 pages)
Subscribe to Our Youtube Channel
Related Manuals for ProActiv NJ1
Summary of Contents for ProActiv NJ1
- Page 1 MOBILITY MADE SIMPLE! Operating instructions NJ1 e-assistant Operating instructions Service booklet NJ1 e-assistant...
-
Page 2: Table Of Contents
Operating instructions NJ1 e-assistant Contents Preface ............................... 3 Legend ..............................3 CE Declaration of Conformity / other information ................3 Classification ..........................3 Declaration of Conformity ......................3 ... - Page 3 Operating instructions NJ1 e-assistant 18.4 Gear shift ..........................13 18.4.1 Chain shift ........................13 18.4.2 Hub gears ........................14 18.4.3 Pedal bearing gearshift ....................15 18.5 Disc and rim brakes ........................15 ...
-
Page 4: Preface
Classification Congratulations on purchasing your new PRO ACTIV product. You have bought a quality The NJ1 e-assistant (referred to as a "product" product which has been especially customised below) is classified as a class I product. to meet your requirements. -
Page 5: Introduction
Operating instructions NJ1 e-assistant • can move and control their hands and Introduction arms so that they are able to operate the controls and perform the full steering Before starting your journey, familiarise movement without restrictions while driv- yourself with these operating instructions pay- ing. -
Page 6: Technical Specifications
Operating instructions NJ1 e-assistant Climbing power It is recommended that you fit the wheel- chair with an anti-roll back device and to acti- The climbing power refers to the ability of the vate this before driving on slopes. The anti-roll... -
Page 7: Commissioning
Operating instructions NJ1 e-assistant Commissioning 11 Safety instructions - prior to driving / use The product is handed over to you ready to use by a PRO ACTIV dealer. They will fit, if not The operating instructions of the con-... -
Page 8: Safety Instructions - While Driving / Using
Operating instructions NJ1 e-assistant Check tyre pressures at regular intervals. In rooms, tight or dangerous areas or Ensure that you comply with the manufac- when manoeuvring, the product may only be turer's specifications which are fitted to the used with the drive inactive and turned off to tyres. -
Page 9: Safety Instructions Regarding Obstacles
Operating instructions NJ1 e-assistant The driving characteristics of the product If the weight load on the drive wheel falls can be influenced by electromagnetic fields (e.g. when driving on slopes) or when driving which can be produced by mobile phones or on loose / slippery surfaces, the braking action other radiating devices. -
Page 10: Safety Instructions Regarding Dangerous Locations And Dangerous Situations
Operating instructions NJ1 e-assistant operated. In this way rolling away due to unin- 14 Safety instructions regarding tentional drive commands, for example, can be dangerous locations and dan- prevented. gerous situations The grip of the tyres on the ground is re- The operator of the product determines the duced in the wet. -
Page 11: Functional Elements
Operating instructions NJ1 e-assistant The product may only be adapted and detached on dry, stable and flat surfaces. 18 Functional elements 18.1 Parking stand 18.1.1 Active and passive positions By pressing down and turning the operating lever, the parking stand positions can be changed from the active to the passive posi- tion, or vice versa. -
Page 12: Pedal Bearing Support & Crank
Operating instructions NJ1 e-assistant 18.2 Pedal bearing support & crank 18.2.1 Seating position The seating position and therefore the pedal position and the pedal crank length depend on the upper-body stability or the core muscula- Distance crank ture. A suitable adjustment to the arm length... -
Page 13: Crank Length And Grip Width
Operating instructions NJ1 e-assistant housing can be moved along the pedal check the chain length and the cable lengths and adjust them if necessary. bearing support to the correct position. Af- ter this, tighten up the clamp screws to 7... -
Page 14: Grips
Operating instructions NJ1 e-assistant The controls for the gear change are normally Pedal bearing designed so that they can be operated using thumb / index finger switching fittings or Hand grip with a chin control (based on the thumb / index rotary axle finger switching fittings). -
Page 15: Hub Gears
Operating instructions NJ1 e-assistant For more information, please see the instruc- right: operation left: operation 3- tions provided by the gear manufacturer. 9-speed cassette speed chain wheels 18.4.2 Hub gears The hub gears integrated into the drive can be Thumb:... -
Page 16: Pedal Bearing Gearshift
Operating instructions NJ1 e-assistant Please refer to the gear or drive manufactur- ers' instructions for more information about the hub gears. 18.4.3 Pedal bearing gearshift Figure 21: Original semi-fluid grease in the syringe The pedal bearing gearshift is switched on by... -
Page 17: Back-Pedal Brake & Crank Release Function
Operating instructions NJ1 e-assistant You can find further information in the brake The brake force applied is adjusted by the manufacturer's instructions. strength of the backwards movement of the cranks. The crank release function is operated by 18.6 Back-pedal brake & crank release pressing the side pressure plate. -
Page 18: Parking Brake
Operating instructions NJ1 e-assistant 18.7 Parking brake 18.9 Components & drive system Using the aluminium bracket which is attached You will be instructed about the functions and to the left-hand side of the pedal bearing sup- operation of the drive support, gears, brakes... -
Page 19: Transport
Operating instructions NJ1 e-assistant 21 Malfunctions If the product should be stored or not used for a long time, the device should be turned on In the event of any malfunctions which cannot briefly once a month and driven a few metres... -
Page 20: Maintenance
Operating instructions NJ1 e-assistant 23 Maintenance Gear and brake cables or brake lines should be checked for any kinks or crush- 23.1 General instructions ing. The product is not a maintenance-free device. Check the brake pads. Therefore, please observe the following in- ... -
Page 21: Proof Of Maintenance
Any modifications to the product which of www.proactiv-gmbh.com. In any event, keep have not been expressly approved by PRO all documents / service reports as a means of ACTIV will invalidate the warranty. -
Page 22: Appendix: Avoiding Crossed Gears With The Chain Shift
Operating instructions NJ1 e-assistant 28 Appendix: Avoiding crossed gears with the chain shift from the large from the small from the middle from the large from the small chain wheel, you chain wheel, you chain wheel, you chain wheel, you... -
Page 23: Appendix: Tightening Torques And Securing Details
Operating instructions NJ1 e-assistant 29 Appendix: Tightening torques and securing details The following table shows the torques for shaft screws with a metric control thread (valid if the drawing or assembly instructions do not state different values!): Torque MA in Nm depending on how tight the screws are Dimension Stability 8.8... -
Page 24: Appendix: Medical Product Passport / Record Of Training
Operating instructions NJ1 e-assistant 30 Appendix: Medical product passport / record of training Product specifications: Serial number: Key number: Customer data: Surname, forename: Street: Postcode, city: Phone: Paying organisation: Training carried out by: Medical supplies dealer PRO ACTIV field representative... -
Page 25: Appendix: Hand-Over Certificate
Operating instructions NJ1 e-assistant 31 Appendix: Hand-over certificate 31.1 Required compliance criteria to authorise use completed / Topics Remarks fulfilled The product is suitable for the customer based on their own judgement and the customer informa- tion received regarding the disability-related re- strictions. -
Page 26: Check List For Training The User
Operating instructions NJ1 e-assistant 31.2 Check list for training the user completed / Topics fulfilled Advised of the applicable legal regulations when driving on public roads. All mechanical and electrical functional controls were explained and their function demonstrated. Adaptation of the adapter to the wheelchair and removing the adapter from the wheelchair was demonstrated and then performed by the user themselves and / or their assistant. -
Page 27: Appendix: Inspection Lists
Operating instructions NJ1 e-assistant 32 Appendix: Inspection lists Initial inspection: After 200 km or 5 months OK / not OK resolved Kilometre reading:___________________ carried out Check all screws / fastening elements are firmly seated Functional / safety check of all lights, steering, adaptation... - Page 28 Operating instructions NJ1 e-assistant Subsequent inspection: After a further 1000 km or 1 year after the last inspection or after heavy use OK / not OK resolved Kilometre reading:___________________ carried out Check all screws / fastening elements are firmly seated...
- Page 29 Operating instructions NJ1 e-assistant Subsequent inspection: After a further 1000 km or 1 year after the last inspection or after heavy use OK / not OK resolved Kilometre reading:___________________ carried out Check all screws / fastening elements are firmly seated...
- Page 30 Operating instructions NJ1 e-assistant Subsequent inspection: After a further 1000 km or 1 year after the last inspection or after heavy use OK / not OK resolved Kilometre reading:___________________ carried out Check all screws / fastening elements are firmly seated...
- Page 31 Operating instructions NJ1 e-assistant Subsequent inspection: After a further 1000 km or 1 year after the last inspection or after heavy use OK / not OK resolved Kilometre reading:___________________ carried out Check all screws / fastening elements are firmly seated...
- Page 32 Operating instructions NJ1 e-assistant Subsequent inspection: After a further 1000 km or 1 year after the last inspection or after heavy use OK / not OK resolved Kilometre reading:___________________ carried out Check all screws / fastening elements are firmly seated...
- Page 33 Operating instructions NJ1 e-assistant Subsequent inspection: After a further 1000 km or 1 year after the last inspection or after heavy use OK / not OK resolved Kilometre reading:___________________ carried out Check all screws / fastening elements are firmly seated...
- Page 34 Operating instructions NJ1 e-assistant Subsequent inspection: After a further 1000 km or 1 year after the last inspection or after heavy use OK / not OK resolved Kilometre reading:___________________ carried out Check all screws / fastening elements are firmly seated...
- Page 35 Operating instructions NJ1 e-assistant Subsequent inspection: After a further 1000 km or 1 year after the last inspection or after heavy use OK / not OK resolved Kilometre reading:___________________ carried out Check all screws / fastening elements are firmly seated...
- Page 36 Operating instructions NJ1 e-assistant Subsequent inspection: After a further 1000 km or 1 year after the last inspection or after heavy use OK / not OK resolved Kilometre reading:___________________ carried out Check all screws / fastening elements are firmly seated...
- Page 37 Operating instructions NJ1 e-assistant Subsequent inspection: After a further 1000 km or 1 year after the last inspection or after heavy use OK / not OK resolved Kilometre reading:___________________ carried out Check all screws / fastening elements are firmly seated...
- Page 38 Operating instructions NJ1 e-assistant Subsequent inspection: After a further 1000 km or 1 year after the last inspection or after heavy use OK / not OK resolved Kilometre reading:___________________ carried out Check all screws / fastening elements are firmly seated...
- Page 39 Operating instructions NJ1 e-assistant Subsequent inspection: After a further 1000 km or 1 year after the last inspection or after heavy use OK / not OK resolved Kilometre reading:___________________ carried out Check all screws / fastening elements are firmly seated...
- Page 40 Operating instructions NJ1 e-assistant Your dealer: PRO ACTIV Reha-Technik GmbH Im Hofstätt 11 72359 Dotternhausen - Germany Tel. +49 7427 9480-0 Fax +49 7427 9480-7025 E-Mail: info@proactiv-gmbh.de www.proactiv-gmbh.com...
Need help?
Do you have a question about the NJ1 and is the answer not in the manual?
Questions and answers