Table of Contents
Advertisement
Operating instruction RAPTOR 4all & 4you
The product must not be cleaned using
steam or high pressure.
If you need care products for your product,
please contact PRO ACTIV.
28 Maintenance
28.1 General instructions
The product is not a maintenance-free device.
Therefore, please observe the following
instructions about maintenance.
For tyres with tread: As soon as there is
one or more points with less than 1 mm of
tread on the tyres of the product, the tyres
must be changed as otherwise there is an
increased risk of an accident.
For tyres without thread: As soon as there
is one or more points where the tyre carcass or
the puncture-proofing is visible on the product,
the tyres must be changed as otherwise there
is an increased risk of an accident.
When maintaining the brakes and the
gear components, it is imperative that the
operating instructions of the manufacturer
which were included in delivery are followed.
Only manufacturer's original parts may be
used when ordering spare parts.
Repairs and conversions to the product
may only be carried out by your dealer or
PRO ACTIV.
Tightening torques and securing details for
fastening elements as shown in the table in
chapter 34 must be observed.
28.2 Service schedules
There is some maintenance work or checks
which should be carried out by the user
themselves at regular intervals (approximately
every 4 weeks depending on the frequency of
use):
The chain should be cleaned and
lubricated with chain oil (observe the
manufacturer's instructions).
Check the tyres for damage, foreign bodies
and any cracks that form.
Check the function and ease of running of
the quick release axles on the running
wheels.
Check the cable housings are seated
correctly and tightly in the gear cable
holders.
Cables and lines should be checked for
kinks and crushing.
Check the brake pads.
Check the tyre pressure and correct if
needed (the tyre pressure should always
be as printed on the tyre covers).
If you should discover any problems
during these checks, please immediately
contact your dealer or PRO ACTIV. Service
and repair work on the product may only be
carried out by your dealer or PRO ACTIV.
In addition to these maintenance tasks /
checks by the user, PRO ACTIV has
prescribed maintenance tasks to be carried
out by the dealer or PRO ACTIV for safe
operation of the product and to minimise the
risk to the user or third-parties.
The initial inspection is performed after running
200 kilometres or 5 months after delivery
(whichever comes first). The maintenance
schedule can be found in the inspection lists in
chapter 37.
Subsequent inspections are then always
performed after 1,000 kilometres running or
after a period of 1 year (whichever comes first).
The maintenance schedule can be found in the
inspection lists in chapter 37.
After extreme loads, e.g. during holidays where
the product was used on sand, near sea water
or in snow, it is recommended that an
additional deep clean and inspection is
performed by your dealer or PRO ACTIV.
24
Advertisement
Table of Contents
