Table of Contents
Advertisement
20 Malfunctions
In the event of any malfunctions which cannot
be solved by yourself based on the operating
instructions included in the scope of delivery,
please contact your specialist retailer or
PRO ACTIV directly.
Malfunctions must be solved before any
further use or, if they occur during the journey,
this must be interrupted immediately.
21 Cleaning and care
Regular cleaning of the product is prescribed
to prevent the components becoming clogged
up due to dirt. Moreover, regular cleaning
prevents corrosion and increased wear. In
particular, the product should be carefully
cleaned after every major use, e.g. summer or
winter holidays.
To avoid corrosion and therefore malfunctions
or breakages of components, the product may
not be exposed to any aggressive
environmental influences. If this cannot be
avoided, the product should be cleaned
immediately after such use and moving parts
need to be greased.
For all cleaning processes, only use
commercially available, household cleaning
agents. Do not use any abrasive cleaning
agents or aggressive, acidic cleaners, to
prevent scratching or fading of the coating or
the anodised parts.
In case the product becomes wet when using,
please dry it after use.
The drive wheel should be regularly cleared of
contamination. It is recommended that you use
a soft sponge or a soft brush.
The product must not be cleaned using
steam or high pressure.
If you need care products for your product,
please contact PRO ACTIV.
17
Operating instructions SPIKE adaptive bike
22 Maintenance
22.1 General instructions
The product is not a maintenance-free device.
Therefore, please observe the following
instructions about maintenance.
For tyres with tread: As soon as there is
one or more points with less than 1 mm of
tread on the product or the adapted
wheelchair, the tyres must be changed since
otherwise there is an increased risk of an
accident.
For tyres without thread: As soon as there
is one or more points where the tyre carcass or
the accident protection is visible on the product
or the adapted wheelchair, the tyres must be
changed since otherwise there is an increased
risk of an accident.
When maintaining the brakes and the
gear components, it is imperative that the
operating instructions of the manufacturer
which were included in delivery are followed.
Only manufacturer's original parts may be
used when ordering spare parts.
Repairs and conversions to the product
may only be carried out by your dealer or
PRO ACTIV.
Tightening torques and securing details for
fastening elements as shown in the table in
chapter 27 must be observed.
Advertisement
Table of Contents
