Table of Contents
Advertisement
to max. 1 cm larger. In this case, the product
can be inserted into the adapter by tipping
slightly to the rear (via the parking stand).
Front of the
insertion
maul
Dimension
from the
ground to
the lower
edge of the
front
Figure 6: Measurement from the ground to the lower
edge of the front of the insertion maul
Insertion
bolt
Figure 7: Dimension from the ground to the lower
edge of the insertion bolt
11
Operating instructions SPIKE adaptive bike
Dimension from
the ground to
the lower edge
of the insertion
bolt
Figure 8: Position of the product and wheelchair
with the parking stand height adjustment set
correctly
The height adjustment of the parking stand
is carried out by undoing the M6 oval head
screw (AF 4 mm) and adjusting the position of
the adjustment inlet along the specified row of
holes in the parking stand and inlet. Finally,
tighten the oval head screw up to 7 Nm of
torque.
Figure 9: M6 oval head screw and adjustment inlet
to adjust the height of the parking stand
17.2 Pedal bearing support & crank
17.2.1 Seating position
The seating position and therefore the pedal
position and the crank length depend on the
upper-body stability or the core musculature. A
suitable adjustment to the arm length will have
been made during the consultation /
measurement procedure.
M6 oval head
screw
Adjustment
inlet
Advertisement
Table of Contents
