3. Pull out the Debris Separator window to expose the
mesh filter. Using a small brush, brush any core par-
ticles from the mesh filter. Using an external vacuum,
remove any remaining debris/powder.
4. a. Wipe down Fast Axis Rails with a dry paper towel and
re-zero stops.
NOTE: Do not use water or any solvents to wipe the printer.
b. Wipe the bottom of the print head (only in one (1) direction) with a
clean lint-free wipe before each build. Use the kit mirror to inspect
the print head for any excess residual fluid.
5. Remove wiper from Service Station (while wearing
safety gloves) and place in acetone.
3D Systems, Inc.
34