Valcom IP bold series Installation & Operation Instructions page 34

name - unit name in SIP protocol (usually line number or name without
diacritics)
Auth.ID - name for SIP server registration
Heslo - password for SIP server registration
Send registration – when registration is necessary (mostly yes) then this
parametr must be used
Registration server - IP adress or server name of registration server (in most
systems and installations is enough to insert IP adress).
Registration is performed on this server. When you dont mark
send registration then dont fill Registration server and IP adres sof
SIP server write to Proxy server.
Port - SIP port is usually 5060 or 5061
Expiration[sec] – expiration of SIP server registration (period of registration
request repeated sending)
Unregistration during start – when you mark then allways during restart will
be unregistrated
SIP Proxy server - IP adress or server name. Over this server connection is
made. When is not filled then connection makes on Registration
server (but you must mark Send registration)
Port - SIP port is usually 5060 or 5061
Outbound proxy - IP adress or proxy name where is determine where will be
sends door entry requests. If outbound proxy is setup will be
INVITE regest sends to outbound proxy adress. Outbound proxy
is used due NAT. When is not used dont fill up.
Port - SIP port is usually 5060 or 5061
Provisional code – determine if during ringing will be sends SIP code „180
Ringing" or „183 Session progress"
Symetric RTP enable - by mark is ON. It means that door entry will not sends
by itself audio to RTP called party, but wait for called party to send
RTP. After sends data to same adress:port from which message
arrived. It is trick used for bridging NAT
Registration status display on page as visible on picture.
34 IP BOLD
- installation and operating instructions