Printer Parameters - OEM VKP80III User Manual

5.4 Printer parameters

This printer allows the confi guration of the parameters listed in the following table.
The parameters marked with the symbol
Settings remain active even after the printer has been turned off and they are stored in non-volatile memory.
PRINTER EMULATION
RS232 BAUD RATE
RS232 DATA LENGTH
RS232 PARITY
RS232 HANDSHAKING
BUSY CONDITION
USB MASS STORAGE
USB ADDRESS NUMBER Numerical address code for the univocal identifi cation of the USB device (in case of
D are the default values.
Available emulations for the device:
VKP80III D
VKP80II
Communication speed of the serial interface:
D
115200 19200
57600 9600
38400 4800
NOTE: Parameter valid only with serial interface.
Number of bit used for characters encoding:
7 bits/car
D
8 bits/car
NOTE: Parameter valid only with serial interface.
Bit for the parity control of the serial interface:
D
None = parity bit omitted
Even = even value for parity bit
Odd = odd value for parity bit
NOTE: Parameter valid only with serial interface.
Handshaking:
XON/XOFF = software handshaking
D
Hardware = hardware handshaking (CTS/RTS)
NOTE: Parameter valid only with serial interface.
NOTE: When the receive buffer is full, if handshaking is set to XON/XOFF, the printer sends the XOFF
($13) on the serial port. When the receive buffer has cleared once again, if handshaking is set to XON/
XOFF, the printer sends the XON ($11) on the serial port.
Activation mode for Busy signal:
OffLine/ RXFull = Busy signal is activated when the printer is both in OffLine status
and the buffer is full
RXFull D = Busy signal is activated when the buffer is full
NOTE: Parameter valid only with serial interface.
Sharing mode from Mass Storage:
D
Disabled = sharing mode disabled
Enabled = sharing mode enabled
NOTE: The parameter is printed only with VKP80III emulation enabled
more than a USB device connected with the same PC):
0 D 2 4
1 3 5
2400
1200
6 8
7 9
5. CONFIGURATION
VKP80III 41
User Manual