OEM VKP80III User Manual page 90

10. ALIGNMENT
VKP80II, VKP80III EMULATION
To defi ne the alignment point you need to set the printer parameters that compose the numerical value of the "Notch
Distance" parameter.
For example, to set a notch distance of 15mm between the notch and the alignment point, the parameters must be
set on the following values:
Notch Distance Sign
Notch Distance [mm x 10]
Notch Distance [mm x 1]
Notch Distance [mm x .1]
The "Notch Distance" parameter, may be modifi ed as follows:
• during the Setup procedure of the device (see chapter 5)
• by using the $1D $E7 command (for more details, refer to the Commands Manual)
• by driver.
90 VKP80III
User Manual
: +
: 1
: 5
: 0